rj_curver
----------

This is a waveshaping module. It has a sleeper built-in. Put it after
an oscillator or well-behaved signal. Probably this is more useful on
sloped waveshapes rather than square/pulse. 

The Input pin is the signal from the Oscillator. (If the signal is not within the normal range, there may be clipping.)

The Curve pin changes the curve of the wave from concave (on either side of the zero-crossing) to convex: a sine goes from squarer to double-sided nippled shape. -5 to +5 volts.

The Squeeze pin adds a gap (multiply, bias, clip).  -5 to +5 volts (On high-settings of the squeeze pin and with high notes, you may get some ugly artifacts.)

The Wake pin is used by the sleeper.  Connect all ADSRs that are connected to your VCAs (or equivs) to the Wake pin, and when they finish (i.e. when there is 0Volt signal from the summed ADSRs) and they go to sleep, the rj_curve's output will also go to sleep. This will cascade to subsequent modules.

Available for unrestricted use. No warranty of quality or fitness for purpose
made. No promise of maintenance.

Copy it into Modules/MyModules